|
Engine
Modifications |
Lexus AFM with
custom air bypass screw.
HKS SMF air filter,
RC Lucas 550cc low impedance injectors
Malpassi adjustable rising rate fuel regulator.
Bosch motor sport 600HP fuel pump.
HKS twin power ignition amplifier.
Custom Oil/Air separator
TRD 8 litre magnesium sump with TRD high flow oil pump and
modified pickup
Block has been
decked. A HKS 2mm stopper type metal head gasket has been used.
TRD oil pump and sump has been used. Oiling system has been
modified for increased flow. ARP Head bolts have been used. |
|
|
Mines ECU, Apexi AVC-R electronic boost controller & Apexi S-AFC. |
 |
Ported intake and
exhaust ports, CC'd head, TRD 60 lb Valve springs, Head has been
decked, Intake and exhaust manifolds have been port matched to the
head.
HKS 264 degree camshafts with 8.1mm of lift. |
 |
JE .5mm oversized
forged pistons taking capacity to 2989cc.
Compression ratio has been reduced to xx:1 |
 |
|
|
Transmission
& Differential Modifications |
C's short shifter
kit & TRD gear knob.
5 puck brass clutch has been used with a modified pressure plate.
New flywheel bolts have been used. |
 |
|
|
Turbocharger,
Intercooler, Intake &
Exhaust Modifications |
|
Hi Flowed CT-26,
Compressor housing has been extrude honed and contains a 57mm
Compressor wheel, cropped exhaust wheel, HPC coated Exhaust
housing, modified waste gate and a 4" HPC coated dump pipe
reducing to 3" before the catalytic converter followed by a Trust
Power Extreme 80mm exhaust |
 
 |
|
HKS adjustable cam
gears |
 |
Intake manifold has
been machined and combined with a Group A 65mm Throttle body.
HKS Intercooler, HKS Super Sequential blow-off valve, HKS crossover pipe,
custom stainless steel intercooler piping. |
 |
|
|
Suspension, Brakes & Wheels |
Tokico Illumina
T.E.M.S Shock Absorbers with Kings Springs, HKS T.E.M.S controller
& Cusco front strut tower bar.
JZA-70 Type-R charcoal grey 5 spoke wheels -
now replaced with ??? 18's.Ohlins Coil overs
with Tein pillow ball mounts were previously fitted.
Work ReZaz 18" x 8" wearing Yokohama 235 x 40 x 18 on the front
and 18" x 9" wearing Nankang 265 x 35 x 18 on the rear
|
|
|
Exterior Modifications |
Group A front bar
air vent
 |
|
|
Interior Modifications |
 |
|
|
Quarter mile times & Dyno
figures. |
 |
